PhotoSpring 10in Frame
In the Box
In the box you should see a PhotoSpring 10in frame, a charging stand and AC charger. Take out them all out. Save the box just in case.
Power up the Frame
First find a place for the frame
It should be:
- close to a power outlet
- in an area where it can be easily seen
- away from glare producing light
Plug the AC Adapter the a power outlet
Plug the other end of the AC Adapter into the back of the charging stand.
Place the frame onto the charging stand
On the bottom of the frame you should see a set of 4 holes. The middle two holes go onto the charging stand.
Just place those middle two holes right on top of the corresponding fittings on the charging stand.....
It should fit like you see here:
Press the power button for 10 seconds to power the frame up. The power button is the largest button located on the back of the frame.
PhotoSpring 8 in Frame
In the Box
In the box you should see a PhotoSpring 8 in frame, a kick stand and AC charger. Take out them all out. Save the box just in case.
Power up the Frame
First find a place for the frame
It should be:
- close to a power outlet
- in an area where it can be easily seen
- away from glare producing light
Optional but recommended: Connect the stand
The stand that comes with your PhotoSpring 8in frame allows the frame to lean at an optimal viewing angle for placement on a desk, table or nightstand. It is also more stable than using the frame without the stand.
To connect the stand to the frame, first find the holes where the stand will connect to. Shown here circled in red and blue.
1. First, insert the small pointed side of the stand into the corner circled in red.
2. Then pivot the stand to snap it into the slot circled in blue above.
Plug the AC Adapter the a power outlet
Plug the other end of the AC Adapter into the back of the frame, near the stand
Press the power button (circled in green below) for 10 seconds to power up the frame
For frames that don't power up....
If your frame doesn't automatically power up
|
Press the silver power button on the back of the frame for 5 seconds and release. It may take a few seconds for the PhotoSpring power up animation to begin. |
If a battery icon displays while powering up
|
Press the power button again for 5 seconds. It may take a few seconds for the PhotoSpring power up animation to begin. |
Note: Your PhotoSpring should come with a partial battery charge. In some cases the battery may be completely empty. If this is the case please charge the frame for a few hours before setting the device up.
Once powered on, you'll see an animation of the PhotoSpring logo.
A NOTE ON POWER: On some PhotoSpring frames the frame is designed to power on automatically when plugged in. This means when you press the Power Button to power down the frame, it will immediately turn back on. We recommend using Sleep instead of Power off. If you want to power completely off, unplug the AC Adapter first and then power down.
To stay up to date on PhotoSpring's latest features, news and discounts please follow us on Twitter or Facebook.